Check the measurement of new yaw shaft and disk cover parts of the circle beating, with a pair of top Mohs hardness of 4 #, to improve the measurement accuracy of the new deflection tester, increased support the weight of the tested parts. to measure the radial direction of the high-precision parts, end and oblique circle beating. Table frame design is reasonable, from top to bottom, front and rear, left and right adjustment a smooth comfortable, easy to operate, the table frame with good rigidity and improve the detection sensitivity of the instrument. 
 High-precision deflection tester http://www.bthxzw.com/GJDPBJCY.html 
 High-precision deflection tester 
 A. With a Mohs hardness of 4 alloy top and operation of the gear drive, the deflection of the measuring accuracy increases support the weight of the tested parts, precision parts can be measured radial, end and oblique round beating. Especially suitable for grinding products. 
 Two. The instruction sheet through the table frame to adjust the location table frame design is reasonable, from top to bottom, front and rear, regulate smooth comfortable operation is extremely convenient. Table frame, good rigidity, improve the detection sensitivity of the instrument. 
 3. Measuring length: 500mm (A05,) 800mm (A08) 1000mm (A10) 2000mm (A20). 
 Technical parameters: 
 A. Radial rotating accuracy: 0.001mm 
 Two. On the side rails full-length parallel to the two top connections: 
 High-precision deflection tester http://www.bthxzw.com/GJDPBJCY.html 
 The Botou Navistar cast material measuring 
 Tel: 5664468 13373071795 
 Tel: Moods